Product ID:STAIN-RESISTANT ACRYLIC PRIMER, 255-100 WHITE
MSDS Date:08/09/1994
FSC:8010
NIIN:00N090324
Status Code:A
MSDS Number: CHYHM

KELLY-MOORE PAINT CO INC

1015 COMMERICAL ST
SAN CARLOS, CA 94070
US

Emergency Phone: 800-424-9300 (CHEMTREC)

Info Phone: 415-592-8337

Cage: KELLY

KELLY-MOORE PAINT CO INC

SAN CARLOS, CA 94070 US

Telephone: 415-592-8337

Cage: KELLY

ZINC OXIDE (SARA 313) (CERCLA)

CAS: 1314-13-2

RTECS: ZH4810000

Fraction By Weight: 1-<5%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST

MINERAL SILICATES

CAS: 1332-58-7

OSHA PEL N/K

ACGIH TLV: N/K

SILICON DIOXIDE

CAS: 14808-57-0

OSHA PEL N/K

ACGIH TLV: N/K

TITANIUM DIOXIDE

CAS: 13463-67-7

RTECS: XR2275000

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST

SILICA, CRYSTALLINE - QUARTZ

CAS: 14808-60-7

RTECS: VV7330000

OSHA PEL SEE TABLE Z-3

ACGIH TLV: 0.1 MG/M3 RDUST

4-ISOTHIAZOLIN-3-ONE, 2-OCTYL-

CAS: 26530-20-1

RTECS: NX8156900

OSHA PEL SEE TABLE Z-3

ACGIH TLV: 0.1 MG/M3 RDUST

5-CHLORO-2-METHYL-4-ISOTHIOAZOLIN-3-ONE

CAS: 26172-55-4

RTECS: NX8156850

OSHA PEL N/K

ACGIH TLV: N/K

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE: DIZZINESS, HEADACHE, NAUSEA,
CONFUSION, IRRITATION TO UPPER RESPIRATORY TRACT, SKIN & EYE
IRRITATION. CHRONIC: PROLONGED AND/OR REPEATED OVEREXPOSURE TO HIGH
CONCENTRATIONS OF RESPIRABLE (AIRBO RNE) CRYSTALLINE-SILICA DUSTS
AS MAY BEGENERATED BY SANDING OR GRINDING OF DRIED PAINTS AND OTHER
(EFTS OF OVEREXP)
Explanation of Carcinogenicity:SILICA, CRYSTALLINE-QUARTZ: IARC MONO,
VOL 68, 1997: GROUP 1. NTP 7TH ANNUAL RPT ON CARCINS, 1994: ANTIC
TO BE CARCIN.
Effects of Overexposure:HLTH HAZ: BUILDING MATERIALS WITHOUT WEARING
PROPER NIOSH APPRVD RESPIRATORY PROTECTION CAN CAUSE SILICOSIS, A
NON-CANCEROUS LUNG DISEASE THAT CNA RESULT IN SUBSTANTIAL
IMPAIRMENT OF BREATHING FUNCTIO N.
Medical Cond Aggravated by Exposure:NONE KNOWN. SEE YOUR PHYSICIAN FOR
SPECIFIC MEDICAL OPINION REGARDING YOUR CONDITION.

First Aid:INHALATION: REMOVE TO FRESH AIR. RESTORE BREATHING. CONSULT
PHYSICIAN. EYE CONTACT: FLUSH WITH LARGE VOLUMES OF WATER FOR AT
LEAST 15 MINUTES. GET MEDICAL ATTENTION. SKIN CONTACT: WIPE OFF
WITH A RAG. WASH THOROUGHLY WITH SOAP AND WATER. INGESTION:
CONSULT HOSPITAL EMERGENCY ROOM OR POISON CONTROL CENTER
IMMEDIATELY.

Flash Point:>200F,>93C
Extinguishing Media:NOT APPLICABLE. MEDIA SUITABLE FOR SURROUNDING FIRE
.
Fire Fighting Procedures:NONE. USE NIOSH APPROVED SCBA & FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY EXPLODE (DUE TO
BUILD-UP OF STEAM PRESSURE) WHEN EXPOSED TO EXTREME HEAT.

Spill Release Procedures:VENTILATE AREA TO PREVENT BUILD-UP OF VAPORS.
FOR SMALL SPILLS, SOAK UP WITH ABSORBENT. FOR LARGER SPILLS, DIKE
ARE WITH ABSORBENT MATERIAL AND SCOOP UP LIQUIDS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE UPRIGHT IN SEALED CONTAINERS
AWAY FROM HEAT AND FLAME.
Other Precautions:REMOVE AND WASH CONTAMINATED CLOTHING BEFORE REUSE.

Respiratory Protection:USE A PARTICLE MASK (NIOSH APPRVD TC-21C) TO
AVOID BRTHG SPRAY MIST/SANDING DUST IF LOC VENT IS ADEQ TO KEEP VAP
CONCS W/IN ACCEPTABLE (TLV) LIMITS. IF LOC VENT IS NOT SUFFICIENT
OR WHERE EXPOSURE LIM ITS ARE EXCEEDED, WEAR (SUPDAT)
Ventilation:LOC CROSS-VENT/MECH EXHAUST SUFFICIENT TO KEEP ALL HAZ VAP
CONCS BELOW PRESCRIBED LIMITS.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPRVD EYE WASH & DELUGE SHOWER .
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
VAP DENS: LIGHTER THAN AIR (WATER VAPOR). RESP PROT: SUITABLE, PROPERLY
FITTED RESP (NIOSH APPRVD TC-23C OR BETTER) FOR ORG VAPS W/DUST
FILTER AS NEEDED.

Boiling Pt:B.P. Text:212F,100C
Vapor Density:SUPDAT
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NOT KNOWN
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:50-54

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS FUMES WHEN
HEATED TO DECOMPOSITION.

Waste Disposal Methods:DISCARD IN LAND FILL IN SEALED METAL CONTAINERS
AWAY FROM HEAT AND FLAME AND IN ACCORDANCE WTIH FEDERAL, STATE AND
LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.